3dlabs Wildcat 4210 Manuel d'utilisateur télécharger pdf (Page 17)

Connecting the Monitor

Your Intense3D Wildcat 4210 video card was factory installed prior to shipment if you purchased it as part

of a system. If you installed the card yourself, you will need to install the video driver software after

connecting the monitor. See “Installing the Software” in this chapter for instructions.

To connect the monitor:

1. Make sure the power to the computer is turned off.

2. See the documentation that came with your monitor for information on the type of

connection that is required. Your monitor cable will have either a Digital Video Interface

(DVI)-I connector or a 15-pin VGA connector depending on monitor type. If your

monitor is a VGA monitor. See “To Connect a VGA monitor” in this chapter.

CAUTION: If you are connecting only one monitor to the Wildcat 4210, you must plug that monitor

into the Primary DVI-I port (see Figure 3).

NOTE: Multiple monitor support is available only under Windows 2000. If you are connecting an

additional monitor to the Intense3D Wildcat 4210, connect the additional workstation monitor’s

video cable to the secondary DVI-I port. See “Enabling the Dual Monitor Feature Under

Windows 2000” later in this document for information concerning configuring dual displays.

To connect a DVI monitor:

1. Connect the workstation monitor’s video cable to the primary DVI-I port on the

Intense3D Wildcat 4210 video card (see Figure 3).

2. Turn on power to the workstation. If the monitor’s Power On LED does not illuminate or

the monitor does not display the startup sequence, consult Chapter 4, “Troubleshooting.”

Figure 3. Wildcat 4210 Digital Video Output

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 46 47

Pas de commentaire

3dlabs Wildcat 4210 Manuel d'utilisateur Page 17